Product video
RZ038-5A 360-Degree Recessed Ceiling PIR Motion Sensor Switch
$15.00
RZ038-5A is a 100-265 VAC recessed ceiling PIR motion sensor switch for automatic lighting control in residential and light commercial rooms.
The 5A model uses live, neutral, and load wiring and provides 360-degree PIR coverage, adjustable time delay, selectable Lux threshold, and high/low sensitivity for ceiling-mounted occupancy control.
- 100-265 VAC商用電圧入力、5Aモデル
- 360-degree PIR detection with 8-12 m detection diameter
- タイムディレイ：15秒〜30分
- 照度設定：オフ、15、25、または35 Lux
- Neutral wire required for AC wiring
製品の特長
- 5A ACモデル： 100-265 VAC recessed ceiling sensor switch for verified RZ038-5A load ratings.
- Ceiling PIR coverage: 360-degree detection with 8-12 m detection diameter under manual conditions.
- 設置設定： タイムディレイ、照度閾値、および高/低感度をプッシュボタンで設定可能。
お探しの製品ではありませんか？ 製品ポートフォリオを見る：
専門家に相談する
Recessed 5A Ceiling Control For Everyday Lighting Loads
The RZ038-5A is a recessed ceiling-mounted PIR motion sensor switch for automatic lighting control where a discreet ceiling sensor is preferred over a wall switch.
It connects to 100-265 VAC circuits with live, neutral, and load wiring, giving installers adjustable time delay, Lux level, and sensitivity in a compact spring-clip ceiling form.
Lux Control For Rooms With Changing Daylight
The built-in light sensor can hold lighting off when ambient light is above the selected threshold, helping the sensor respond to motion only when the room needs light.
Use the Off, 15 Lux, 25 Lux, or 35 Lux setting to match bathrooms, utility rooms, hallways, or other indoor areas where daylight and occupancy change during the day.
特長、メリット、仕様
The RZ038-5A combines 360-degree PIR detection, 100-265 VAC wiring, and verified 5A load ratings so installers can check coverage, setup, and lighting compatibility before ordering.
特長とメリット
- 5A 商用電源（ラインボルト）制御： Supports 100-265 VAC lighting circuits with the source-backed RZ038-5A load ratings shown in the specifications.
- 360-degree PIR detection: Ceiling placement gives broad room coverage with an 8-12 m detection diameter when installed within the manual conditions.
- 調整可能な遅延時間: Choose 15 s, 30 s, 1 min, 3 min, 5 min, 10 min, or 30 min to match the room traffic pattern.
- 選択可能な照度（Lux）しきい値: Set Off, 15 Lux, 25 Lux, or 35 Lux to control whether motion can switch lights on when ambient light is present.
- 高/低感度設定: The SENS button lets installers tune detection response for the room layout.
- Spring clip or screw mounting: Mount into an 82-90 mm ceiling cutout or secure to a ceiling/junction box using the documented methods.
- 機能・特徴
-
型番
RZ038-5A
製品タイプ
Recessed ceiling mount PIR motion sensor switch
センサータイプ
Passive infrared (PIR)
遅延時間
15秒、30秒、1分（デフォルト）、3分、5分、10分、30分
明暗センサーレベル
OFF、15 Lux、25 Lux（デフォルト）、35 Lux
感度
高または低
Power-up behavior
1-minute warm-up after power is turned on or restored
- 電気仕様
-
電源
100 VAC ~ 265 VAC
電源周波数
50/60 Hz
配線
白：中性線（Neutral）、赤：負荷側（Load）、黒：電圧線（Live）
白熱電球 / ハロゲン負荷
500 W / 110 VAC; 1100 W / 220 VAC
蛍光灯 / 安定器 / LED負荷
250 W / 110 VAC; 500 W / 220 VAC
- 検知および設置
-
検知直径
8-12 m when ambient temperature is below 27 C
検知範囲
360度天井カバー
Motion detection speed
0.6-1.5 m/s
設置高さ
2.5-3.5 m
動作温度
-10〜+40 C
動作湿度
< 93% RH
Ceiling cutout
82-90 mm circular hole for spring clip mounting
Face diameter
106 mm
よくあるご質問
Does the RZ038-5A need a neutral wire?
はい。AC配線図に従い、白を中性線（Neutral）、赤を負荷（Load）、黒を電圧線（Live）に接続する必要があります。
5Aモデルはどのような負荷を制御できますか？
取扱説明書によると、白熱灯またはハロゲン負荷の場合は500 W / 110 VACおよび1100 W / 220 VAC、蛍光灯、安定器、またはLED負荷の場合は250 W / 110 VACおよび500 W / 220 VACと記載されています。
Can the sensor keep lights off during bright daylight?
Yes. The Lux button can set Off, 15 Lux, 25 Lux, or 35 Lux, so the light sensor threshold can be matched to the room.
Where should this ceiling sensor be installed?
The manual recommends a 2.5-3.5 m installation height and advises avoiding heat sources, forced air, ventilation systems, ceiling fans, and hanging light fixtures near the sensor.
What happens after power is restored?
The sensor has a 1-minute warm-up period after power-up or power restoration. During that time it will not automatically control the load.
Should I choose the 5A or 10A RZ038 model?
Choose by verified load requirement. The 10A model has higher source-backed load ratings, while the 5A model is for lower-load AC lighting circuits.
レビュー
レビューはまだありません。