{"id":19964,"date":"2026-01-09T02:44:15","date_gmt":"2026-01-09T02:44:15","guid":{"rendered":"https:\/\/staging.rayzeek.com\/uncategorized\/split-level-stair-sensor-timing"},"modified":"2026-01-09T02:45:09","modified_gmt":"2026-01-09T02:45:09","slug":"split-level-stair-sensor-timing","status":"publish","type":"post","link":"https:\/\/staging.rayzeek.com\/sv\/blogg\/split-level-stair-sensor-timing\/","title":{"rendered":"Trappor med halvplan r\u00f6relsesensorer: Hur man stoppar avsatsens \"stroboskop\" och beh\u00e5ller ljuset f\u00f6re dig"},"content":{"rendered":"

A common split-level scene looks boring until it doesn\u2019t. Someone comes up from a finished basement, hits the landing, pivots with a foot on each level, and the stair light snaps off, then back on, then off again. The complaint that follows is almost always phrased like a device problem: \u201cIt\u2019s not sensitive enough,\u201d or \u201cIt\u2019s flickering,\u201d or \u201cThis sensor is junk.\u201d<\/p>

But on split-level stairs, the landing is the trap. The geometry and the way people actually move\u2014boots in winter, hands full of groceries, a pause to turn\u2014breaks the default assumptions most PIR wall switches make, especially at a 30\u2011second factory timeout.<\/p>

The light should stay ahead of you.<\/p>

The fastest way to waste a weekend is chasing \u201cmore sensitivity\u201d as the first fix. Detection range is rarely the failure. The real issue is what happens when motion stops for two seconds in a spot where the sensor can\u2019t see a torso. If the homeowner’s trigger phrase is \u201csensor misses me when I stop,\u201d that is the hint to adjust the hold time and line-of-sight before touching sensitivity. Split-level stairs punish twitchy timing. They also punish a sensor aimed straight down a stair run that only sees shins from one direction.<\/p>

When people say \u201cstrobing,\u201d it helps to define terms before replacing fixtures. In a 1994 tri-level, a phone video of an on\u2011off\u2011on pattern right at the landing looked like flicker, but it tracked the person\u2019s pivot perfectly. The LED driver responded to rapid power cycling, but the cause was control behavior: short delay, awkward retrigger logic, and a landing pause that created a dead zone. If the on\/off events line up with the steps and the pivot, treat it as control flutter tied to movement patterns. The wiring usually isn\u2019t haunted; the staircase is exposing timing and coverage mistakes.<\/p>

What a PIR Is Actually Doing on a Landing<\/h2>

A PIR wall switch doesn’t read minds, and it doesn’t measure \u201coccupancy\u201d the way people use the word. It watches for changes in infrared patterns across its window. On a straight hallway, that works well because motion is continuous and mostly perpendicular to the sensor\u2019s view.<\/p>

On split-level stairs, the route changes: approach from the basement or main floor, pause at the landing, pivot, then continue. That pause is the key. The switch sees motion (trigger), starts its hold time, and applies internal rules about retriggering. If the hold time is short and the sensor has a dead spot during the pause, the light cuts out while the person is still on the stairs. The pivot creates motion again, so the light pops back on. That\u2019s the \u201cstrobe,\u201d and the stairs are doing it on schedule.<\/p>

This is where people get annoyed: short timeouts are marketed as efficient, but on stairs, they\u2019re a bad trade even before safety is mentioned. In a 12\u2011unit condo stairwell after an LED retrofit, shaving minutes off the on-time barely moved the electricity bill. It did, however, spike the complaint volume. Residents stood still with keys and packages, plunging into darkness because someone insisted on aggressive shutoff. Once the timeout pushed into the 5\u201310 minute range, tickets dropped to near zero. On modern LED stair fixtures, the \u201cenergy savings\u201d argument for a 30\u2011second timeout collapses in real life. The stair circuit is low wattage; the human cost is not.<\/p>

Kanske \u00e4r du intresserad av<\/h3>
\"\"<\/div><\/a><\/div>

RZ037-DRY Takmonterad PIR-upptagningssensor med torrkontaktrel\u00e4<\/a><\/h4><\/div>